This Race version of the bung bolt is light weight and has holes pre-drilled for lock wiring. The Stainless Steel Wideband Bung Bolt allows you to block off a Wideband O2 bung when the Wideband O2 sensor is not installed. You can weld this bung into exhaust systems that do not have a Wideband O2 bung.
High Quality 18mm Titanium Wideband O2 Bung. High Quality 18mm Stainless Steel Wideband O2 Bung. Zeitronix ZT-3 Wideband O2 Installation Guide
#2021 ZX10R ECU FLASH SOFTWARE#
Purchase this item to gain access in the Woolich Racing Tuned software to the bin files for the 2015-2021 Kawasaki H2.įeatures available for Kawasaki H2 2015-2021 This does not work with the stock Shift Sensor from 2015-2017 models.īin File Definitions - for use in Woolich Racing Tuned softwareĢ015-2021 Kawasaki H2 Bin File Definition This item is for the Race Tools Key Only, it allows you to enable Woolich Racing Race Tools using the stock Shift Sensor from 2018-2021 Models Only.
#2021 ZX10R ECU FLASH INSTALL#
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).
You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. ** The Pit Speed Limiter and Engine Warm Up requires the purchase of an additional Pit Speed Limiter Harness. * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Launch Control allows you to configure Delay, Launch RPM and Hold Speed.Įngine Warm up parameters are fully configurable. Pit Speed Limiter RPM can be configured.**
#2021 ZX10R ECU FLASH FULL#
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Target maps are fully configurable per gear. Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.Kawasaki Race Tools Type 5 which allows the quickshifter to be plugged into the bikes wiring harness**.Shift rod for standard shift configuration*.
0 kommentar(er)
